Appendix; Converting An Autonomous Access Point; Verifying The Software Version Of The Ap521 Access Point - Cisco 521G - Unified IP Phone VoIP Configuration Manual

Converting an Autonomous Access Point

This appendix provides instructions for using CCA to convert an autonomous AP521 access point into
a controller-based (or lightweight) LAP521 access point. The appendix contains these sections:
•
•
•

Verifying the Software Version of the AP521 Access Point

Prior to obtaining the conversion image file for your access point, you must verify the software version.
To verify the software version of the access point, follow these steps:
Check the topology view of your network to ensure an AP521 access point is available (see
Step 1
Note
Figure B-1
Right click on the AP521 access point and choose Properties in the pop-up.
Step 2
OL-15283-01
Verifying the Software Version of the AP521 Access Point, page B-1
Obtaining the AP521 Access Point Conversion Image File, page B-2
Using CCA to Convert an AP521 Access Point, page B-3
An AP521 access point is identified by a circle icon in a small box next to the access point, such
as the access point with an IP address of 192.168.10.23 in
Topology View Containing an AP521 Access Point
A P P E N D I X
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
B
Figure
Figure B-1.
Figure B-2 appears.
B-3).
B-1