C H A P T E R 6 Restarting, Resetting, Backing Up, And Restoring The Controller; Resetting The Controller To Factory Default Values Using Cca - Cisco 521G - Unified IP Phone VoIP Configuration Manual

Chapter 6 Restarting, Resetting, Backing Up, and Restoring the Controller
Figure 6-3
Click Yes to begin the reset process.
Step 5
When the controller reset completes, the window closes automatically.

Resetting the Controller to Factory Default Values Using CCA

To reset the controller to factory default values using the CCA, follow these instructions:
Click Maintenance > Restart/Reset and
Step 1
Figure 6-4
On the controller line, check Reset to Factory Defaults.
Step 2
being in approximately 1 minute for the selected devices. The message indicates CCA will loose
connectivity with the controller after it has been reset to factory defaults. To reconfigure the controller,
go to the
OL-15283-01
Reload Confirmation Pop-Up Message
Restart/Reset Window
"Adding a New Controller" section on page
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
Resetting the Controller to Factory Default Values Using CCA
Figure 6-4 appears.
Figure 6-5
2-2.
appears and indicates the reset will
6-3