Configuring Your Ethernet Adapter To A Static Ip Address; Verifying The Ip Address Of Your Ethernet Adapter - Cisco 521G - Unified IP Phone VoIP Configuration Manual

Verifying and Configuring Your Ethernet Adapter
Step 7 Click OK on your Ethernet adapter properties screen.

Configuring your Ethernet Adapter to a Static IP Address

To configure your Ethernet adapter to a static IP address on a Windows-based PC, follow these
instructions:
Click Start > Control Panel > Network Connections.
Step 1
Right-click on your Ethernet adapter and choose Properties.
Step 2
Scroll down the list of items and click Internet Protocol (TCP/IP).
Step 3
Click Properties and the Internet Protocol (TCP/IP) Properties screen appears.
Step 4
Step 5 Check Use the following IP address.
Step 6 Enter the IP address, the subnet mask, and the default gateway IP address in the corresponding fields.
Step 7 Click OK.
Click OK on your Ethernet adapter properties screen.
Step 8

Verifying the IP Address of your Ethernet Adapter

The IP address of your Ethernet adapter must be configured within the same subnet as your system
components for use with CCA. To verify the IP address of your Ethernet adapter on a Windows-based
PC, follow these instructions:
Click Start > Run and the Run pop-up window appears.
Step 1
Type cmd in the Open field and click OK. The cmd.exe pop-up window appears.
Step 2
In the pop-up window, type ipconfig and press Enter (see
Step 3
Figure 2-13
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
2-10
IPCONFIG Results Window
Chapter 2 Adding a WLC526 Controller and LAP521 Access Points
Figure 2-13).
OL-15283-01