Using The Command-Line Interface - Cisco 521G - Unified IP Phone VoIP Configuration Manual

Chapter 1 Overview
For help with these and other advanced configuration tasks, refer to the GUI online help.

Using the Command-Line Interface

Use the controller command line interface (CLI) if you are experienced using Cisco CLI commands and
want to display system parameters or access debugging information (see
Example 1-1
(Cisco Controller) >show stats switch summary
Packets Received Without Error................... 443557435
Broadcast Packets Received....................... 73998045
Packets Received With Error...................... 0
Packets Transmitted Without Error................ 468934
Broadcast Packets Transmitted.................... 2341
Transmit Packet Errors........................... 0
Address Entries Currently In Use................. 2
VLAN Entries Currently In Use.................... 1
Time Since Counters Last Cleared................. 76 day 6 hr 38 min 23 sec
(Cisco Controller) >
The WLC526 controller is simple to install and operate; therefore, the controller CLI consists of a
Note
limited number of primarily show and debug commands.
OL-15283-01
– Advanced client exclusion policies
Advanced security for access point management
–
Advanced SNMP configuration
–
Advanced controller management configuration
–
Guest Lobby Administrator configuration
–
Advanced controller troubleshooting configuration
–
Advanced log configurations
–
Advanced controller file management configuration options
–
CLI Command Output Example
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
Configuration Options
Example 1-1).
1-9