Compaq 219700-001 - ProLiant - 1500 Reference Manual page 98

6-30
Installing the Operating System Drivers
7. Select Close and exit the Setup program or select other tabbed sections
to install/update/remove other software components.
8. Remove the Windows NT SSD diskette, shut down Windows NT, and
reboot the system to load the driver.
Removing the SMART-2DH Controller
Driver
IMPORTANT:
device attached to a SMART-2DH Array Controller, you will get a dialog box
stating, The selected controller is marked as a boot device. Removing it may
cause the system not to boot.
1. Start Windows NT and log in to an account with administrative
privileges.
2. Insert the Windows SSD diskette (Diskette #1) into the diskette drive.
3. Start Setup by entering
where A: is the letter of the diskette drive.
4. Select Custom Setup.
NOTE:
menu if the Array driver is detected. It will only be displayed in the Express
Setup menu if the Array driver is detected and not installed or not current.
5. Select the Mass Storage tabbed panel on the Custom Installation
screen.
6. Select Compaq Drive Array; then, choose the Remove button.
After the driver has been removed from your system, Setup returns to
the Custom Installation window.
7. Select Close and exit the Setup program or select other tabbed sections
to install/update/remove other software components.
8. Remove the Windows SSD diskette, shut down Windows NT, and
reboot the system to load the driver.
Writer: Pamela King Project: SMART-2DH Array Controller Reference Guide Comments: 295469-002
DO NOT remove this driver if the system is booting from a
A:\setup
The Compaq Array Driver will only be displayed in the Custom Setup
File Name: G-CH06.DOC Last Saved On: 2/27/98 12:01 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED