Installing The Operating System Drivers - Compaq 219700-001 - ProLiant - 1500 Reference Manual

Chapter 6
Installing the Operating System
Drivers
This chapter outlines the driver installation steps to set up the SMART-2DH
Array Controller in a server running any of the following operating systems:
Novell NetWare/intraNetWare
Microsoft Windows NT
SCO OpenServer 5
SCO UnixWare 2.1 or later
IBM OS/2
Banyan VINES
Microsoft Windows 95
This chapter also contains related information for using the SMART-2DH
Array Controller with these operating systems. If you are setting up a new
system, we encourage you to use SmartStart, supplied with the server, to
install both the operating system software and the device drivers for the
SMART-2DH Array Controller.
NOTE:
Support Software CD, all of the software, including device drivers, will be
automatically installed and configured for the SMART-2DH Controller. In
addition, the optimization supplied by the CPQDAOPT.NLM will occur
automatically. The SMART-2DH Controller is supported by SmartStart 3.40 or
later. See the documentation that came with SmartStart for installation
instructions.
Before installing the drivers, you should have:
Updated your system firmware by running System ROMPaq
Installed the SMART-2DH Controller option board
Configured the hardware by running the System Configuration Utility
Writer: Pamela King Project: SMART-2DH Array Controller Reference Guide Comments: 295469-002
If you install the operating system software from the SmartStart and
File Name: G-CH06.DOC Last Saved On: 2/27/98 12:01 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
SMART-2DH Array Controller Reference Guide
6-1