Compaq 219700-001 - ProLiant - 1500 Reference Manual page 121

5. Install the driver:
Log in to Windows 95.
Select Add New Hardware.
Choose NO when prompted to search for hardware.
Select SCSI Controllers.
Select Have Disk button.
In the Install From Disk menu, enter the path to the array directory
\WindowsDir\CPQSYS\ARRAY. The driver will be copied to the
appropriate directory.
For this step to work properly, the following steps must have been
previously executed: (1) a copy of the Windows 95 diskettes has
been made (2) the instructions in the README.1ST file have been
followed, and (3) diskette files have been copied to the hard drive.
Reboot the server for the new settings to take affect.
NOTE: To install SMART-2DH Controller as a primary controller, you must
have the additional SMRT.SYS driver in CONFIG.SYS before booting. Refer to
the README.TXT file on the Windows 95 diskettes.
Interrupt 13h BIOS Support
Interrupt 13h BIOS support in the SMART-2DH Controller Option ROM
provides support for up to eight logical drives total on multiple SMART-2DH
controllers. Controllers can be SMART-2DH or SMART-2/P, or a
combination of the two. To install the SMART-2DH Controller in a Windows
95 environment using the Interrupt 13h BIOS support mode, follow these
steps:
1. Update your system firmware by running System ROMPaq.
2. Install the SMART-2DH Controller option board (see Chapters 3 - 7
for your system).
3. Configure the hardware by running the System Configuration Utility.
Be sure to set these SMART-2DH Controller parameters:
Set the Controller Order of one SMART-2DH Controller to First
(a SMART-2DH Controller must be the primary disk controller).
Writer: Pamela King Project: SMART-2DH Array Controller Reference Guide Comments: 295469-002
File Name: G-CH06.DOC Last Saved On: 2/27/98 12:01 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
SMART-2DH Array Controller Reference Guide
6-53