Cooling Fans - Dell POWEREDGE R515 Hardware User Manual

6 Slide in the optical drive until the latch snaps into place.
7 Connect the optical drive cable to the back of the drive.
You must route these cables properly through the tabs on the system
chassis to prevent them from being pinched or crimped. See Figure 3-1.
8 Connect the data cable to the system board and the interface cable to
SAS_B on the backplane. See Figure 6-1.
9 Close the system. See "Closing the System" on page 85.
10 If applicable, replace the front bezel. See "Removing the Front Bezel" on
page 82.
11 Reconnect the system and peripherals to their electrical outlets, and turn
on the system.

Cooling Fans

Your system contains five cooling fans, single- or dual-motor depending on
your system configuration. These provide cooling for the processor, PCI cards,
memory modules, and power supplies.
NOTE:
Hot-swap removal or installation of the cooling fans is not supported.
NOTE:
In the event of a problem with a particular fan, the fan number is referenced
by the system's management software, allowing you to easily identify and replace
the proper fan by noting the fan numbers on the fan assembly.
Installing System Components
97