Dell POWEREDGE R515 Hardware User Manual page 130

Figure 3-23. Removing and Installing the Heat Sink
1 heat sink
10 Rotate the processor shield upward and out of the way. See Figure 3-24.
11 Lift the processor out of the socket and leave the release lever up so that
the socket is ready for the new processor.
CAUTION:
the processor. Bending the pins can permanently damage the system board.
NOTE:
In single-processor configurations, a processor must be installed in socket
CPU1. Install the blank in socket CPU2 only.
130
Installing System Components
Be careful not to bend any of the pins on the ZIF socket when removing
2 retention screws (4)
1
2