Troubleshooting An Optical Drive - Dell POWEREDGE R515 Hardware User Manual

Troubleshooting an Optical Drive

CAUTION:
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 If applicable, remove the front bezel. See "Removing the Front Bezel" on
page 82.
2 Try using a different CD or DVD.
3 Enter the System Setup program and ensure that the integrated SATA
controller and the drive's SATA port are enabled. See "Entering the System
Setup Program" on page 58.
4 Run the appropriate online diagnostic test. See "Using Online Diagnostics"
on page 177.
5 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
6 Open the system. See "Opening the System" on page 83.
7 Ensure that the interface cable is securely connected to the optical drive
and to the system board.
8 Ensure that a power cable is properly connected to the drive.
9 Close the system. See "Closing the System" on page 85.
10 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
If the problem is not resolved, see "Getting Help" on page 187.
168
Troubleshooting Your System
Many repairs may only be done by a certified service technician.