Figure 3-15. Removing and Installing a Power Supply
1
power supply
3
velcro strap
Installing a Power Supply
1 Verify that both power supplies are of the same type and have the same
maximum output power.
NOTE:
the power supply label.
2 Slide the new power supply into the chassis until the power supply is
fully seated and the release latch snaps into place. See Figure 3-15.
NOTE:
procedure, relatch it. For information about the cable management arm,
see the system's rack documentation.
The maximum output power (shown in watts) is listed on
If you unlatched the cable management arm in step 2 of the previous
4
2
power supply handle
4
release latch
Installing System Components
1
2
3
103