Table of Contents
Advertisement
Prestige 100 and 100IH ISDN Router and Router/Hub
10.7 Command Interpreter Mode
This option allows you to enter the command interpreter mode. A list of valid commands can be
found by typing [help] at the command prompt. For more detailed information, check the ZyXEL
Web site or send e-mail to the ZyXEL Support Group.
Copyright (c) 1999 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys
isdn
10.8 Call Control
The Prestige provides four call control functions: call control parameters, blacklist, budget
management and call history.
Call control parameters allow you to set a dial out time limit, the number of times a number
should be called before it is added to the blacklist and the interim between calls.
The budget management function allows you to set a limit on the total outgoing call time of the
Prestige over a period of time. When the total outgoing call time exceeds the limit, the current call
will be dropped and any future outgoing calls will be blocked.
The blacklist function prevents the Prestige from re-dialing to an unreachable phone number. It is
a list of phone numbers, up to a maximum of 14, to which the Prestige will not make an outgoing
call. If the Prestige tries to dial to a phone number and fails a certain number of times
(configurable in Menu 24.9.1), then the phone number is put in the blacklist. You will have to
enable the number manually before the Prestige will dial that number again.
Call history chronicles preceding incoming and outgoing calls.
10-16
Enter Menu Selection Number: 8
exit
device
ip
ppp
Figure 10-13 Command mode
ether
System Maintenance
Advertisement
Table of Contents
Troubleshooting
