Table of Contents
Advertisement
A remote node is required for placing calls to a remote gateway. A remote node represents both
the remote gateway and the network behind it across a WAN connection. Note that when you use
Menu 4 to set up Internet access, you are actually configuring one of the remote nodes. Once a
remote node is configured correctly, traffic to the remote network will trigger your Prestige to
make a call automatically, i.e., Dial On Demand.
In this chapter, we will discuss the parameters that are protocol independent. The protocol-
dependent configuration (TCP/IP) will be covered in Chapter 5.
4.1
Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
From the Main Menu, select menu option 1. Remote Node Setup
Step 1.
When Menu 11 appears, as shown below, enter the number of the remote node that you
Step 2.
wish to configure.
Remote Node Configuration
Prestige 100 and 100IH ISDN Router and Router/Hub
Remote Node Configuration
Chapter 4
4-1
Advertisement
Table of Contents
Troubleshooting
