10.1 System Status; Figure 10-2 Menu 24.1 - System Maintenance - Status - ZyXEL Communications PRESTIGE 100 - VERSION 2.20 User Manual

Prestige 100 and 100IH ISDN Router and Router/Hub

10.1 System Status

The first selection, System Status, gives you information on the status and statistics of the ports,
as shown below. System Status is a tool that can be used to monitor your Prestige. Specifically, it
gives you information on your ISDN telephone line status, number of packets sent and number of
packets received.
To get to the System Status, select number 24 to go to Menu 24 - System Maintenance. From
this menu, select number 1, System Status. There are five commands in Menu 24.1 - System
Maintenance - Status . Entering 1 disconnects the current B1 channel call; 2 disconnects the
current B2 channel call, 3 resets the counters, 4 drops both B1 and B2 and ESC takes you back to
the previous screen.
The table below describes the fields present in Menu 24.1 - System Maintenance - Status . It
should be noted that these fields are READ-ONLY and are meant to be used for diagnostic
purposes.
Chan Link
-- Down
-- Down
Total Outcall Time:
Ethernet:
Status: 10M/Half Duplex
TX Pkts: 230
RX Pkts: 0
Collisions: 0
LAN Packet Which Triggered Last Call:
COMMANDS: 1-Drop B1
The following table describes the fields present in Menu 24.1 - System Maintenance - Status.
10-2
Menu 24.1 -- System Maintenance – Status
Type TXPkts RXPkts
0Kbps 0
0Kbps 0
0:00:00
Press Command:
2-Drop B2
Figure 10-2 Menu 24.1 - System Maintenance – Status
Errors CLU
0 0
0 0
WAN:
Chan 1 IP Addr:
Chan 2 IP Addr:
Chan 1 CLID:
Chan 2 CLID:
3-Reset Counters 4-Drop All
ALU Up Time
0% 0% 0:00:00
0% 0% 0:00:00
ESC-Exit
System Maintenance