Table of Contents
Advertisement
Prestige 100 and 100IH ISDN Router and Router/Hub
Field
Encapsulation
Compression
Multiple Link Options:
BOD Calculation
Base Trans Rate
Max Trans Rate
Target Utility (Kbps)
Add Persist
Subtract Persist
Once you have completed filling in Menu 11.2 – Remote Node PPP Options, press [Enter] at the
message [Press ENTER to Confirm...] to save your configuration, or press [Esc] at any time to
cancel.
4-8
Table 4-3 Remote Node PPP Options Menu Fields
Description
Select the CISCO PPP only when this remote node
is a Cisco machine; otherwise, select the Standard
PPP.
Turn on/off Stac Compression. The default for this
field is Off.
Select the direction of the traffic you wish to use in
determining when to add or subtract a link. The
default for this field is Transmit or Receive.
Select the base data transfer rate for this remote
node in Kbps. There are two choices for this field-
64 where only one channel is used or 128 where
two channels are used as soon as a packet triggers
a call
Enter the maximum data transfer rate allowed for
this remote node. This parameter is in kilobits per
second. There are two choices for this field- same
as above.
Enter the two thresholds separated by a [-] for
subtracting and adding the second port.
This parameter specifies the number of seconds
where traffic is above the adding threshold before
the Prestige will bring up the second link.
This parameter specifies the number of seconds
where traffic is below the subtraction threshold
before your Prestige drops the second link.
Option
Standard
CISCO
On/Off
(Default =
Default =
Transmit or
Receive
64/128
64/128
Default=10-
Default = 5
Default = 5
Remote Node Configuration
PPP
PPP
Off)
20
sec
sec
Advertisement
Table of Contents
Troubleshooting
