Table of Contents
Advertisement
Prestige 100 and 100IH ISDN Router and Router/Hub
Chapter 9
Telnet Configuration and Capabilities
9.1
About Telnet Configuration
Before the Prestige is properly setup for TCP/IP, the only option for configuring it is through the
console port. Once your Prestige is configured, you can use telnet to configure it remotely as
shown below.
Figure 9-1 Telnet Configuration on a TCP/IP Network
9.2
Telnet Under SUA
When Single User Account (SUA) is enabled and an inside telnet server is specified, telnet
connections from the outside will be forwarded to the inside server. So to configure the Prestige
via telnet from the outside, you must first telnet to the inside server, and then telnet from the
server to the Prestige using its inside LAN IP address. If no insider server is specified, telnet to
the SUA 's IP address will connect to the Prestige directly.
Telnet Configuration
9-1
Advertisement
Table of Contents
Troubleshooting
