ZyXEL Communications IES-1248 VDSL-SWITCH User Manual page 84

IES-1248 User's Guide
LABEL
Fan Speed (RPM)
Current This is the current RPM reading.
MAX This field displays the maximum RPM measured at this point.
MIN This field displays the minimum RPM measured at this point.
Average This field displays the average RPM measured at this sensor.
Threshold (Low) This field displays the lowest RPM limit at this sensor.
Threshold (Hi) This field displays the highest RPM limit at this sensor.
Status Normal indicates that the RPM is within an acceptable operating range at this point;
External Alarm
External Relay
Use this section of the screen to configure the hardware monitor threshold settings.
New threshold
Temperature (Hi)
Temperature (Low)
Volt. (Hi)
Volt. (Low)
Fan (Hi)
Fan (Low)
Poll Interval(s)
Stop
10-4
Table 10-1 System Information
A properly functioning fan is an essential component (along with a sufficiently ventilated,
cool operating environment) in order for the device to stay within the temperature
threshold. Each fan has a sensor that can detect and report the fan's RPM (Rotations Per
Minute).
otherwise Abnormal is displayed.
The IES-1248 is able to detect alarm input from other equipment connected to the ALARM
connector.
The Status column displays Normal when no alarm input has been detected from other
equipment. It displays Abnormal when alarm input has been detected from other
equipment.
The IES-1248 is able to send alarm output to another piece of equipment connected to the
ALARM connector.
The Status column displays Normal when the IES-1248 is not sending alarm output to
another piece of equipment. It displays Abnormal when the IES-1248 is sending alarm
output to another piece of equipment.
Configure new threshold settings in the fields below and click Apply to use them.
Use these fields to configure the highest temperature limit at each sensor.
Use these fields to configure the lowest temperature limit at each sensor.
Use these fields to configure the highest voltage limit at each sensor.
Use these fields to configure the lowest voltage limit at each sensor.
Use these fields to configure the highest RPM limit at each sensor.
Use these fields to configure the lowest RPM limit at each sensor.
The text box displays how often (in seconds) this screen refreshes. You may change the
refresh interval by typing a new number in the text box and then clicking Set Interval.
Click Stop to halt statistic polling.
DESCRIPTION
Basic Setting Screens