ZyXEL Communications IES-1248 VDSL-SWITCH User Manual page 62

IES-1248 User's Guide
LABEL
Switch Setup
IP Setup
ENET Port Setup
xDSL Port Setup
xDSL Profiles Setup
xDSL Line Data
Advanced Application
VLAN
IGMP Snooping
Static Multicast
Filtering
MAC Filter
Spanning Tree
Protocol
Port Authentication
Port Security
DHCP Relay
Syslog
Access Control
Routing Protocol
Static Routing
Management
Maintenance
Diagnostic
MAC Table
ARP Table
Config Save
Config Save
7-4
Table 7-2 Web Configurator Screens
Use this screen to set up global switch parameters such as IGMP snooping, MAC
address learning, GARP and priority queues.
Use this screen to configure the system and management IP addresses and subnet
masks.
Use this screen to configure settings for the Ethernet ports.
Use this submenu to go to screens for configuring settings for individual DSL ports.
Use this submenu to go to screens for configuring profiles for the DSL ports.
Use this submenu to go to screens for viewing DSL line operating values, bit allocation
and performance counters.
Use this submenu to go to screens for viewing and configuring the VLAN settings.
Use this screen to configure IGMP snooping and display the results.
Use this screen to configure static multicast filter entries.
Use this screen to configure packet filtering.
Use this screen to configure MAC filtering for each port.
Use this submenu to go to screens for displaying Rapid Spanning Tree Protocol (RSTP)
information and configuring RSTP settings.
Use this submenu to go to screens for configuring RADIUS and IEEE 802.1x security
settings.
Use this screen to limit the number of MAC address that can be learned on a port.
Use this screen to configure the DHCP relay settings.
Use this screen to configure the syslog settings.
Use this screen to configure the system login password and configure SNMP and remote
management.
Use this screen to configure static routes. A static route defines how the IES-1248 should
forward traffic by configuring the TCP/IP parameters manually.
Use this screen to perform firmware and configuration file maintenance as well as restart
the system.
Use this screen to view system logs and test port(s).
Use this screen to view the MAC addresses (and types) of devices attached to what ports
and VLAN IDs.
Use this screen to view the MAC address to IP address resolution table.
Use this screen to save the device's configuration into the nonvolatile memory (the IES-
1248's storage that remains even if the IES-1248's power is turned off).
DESCRIPTION
Web Configurator Introduction