ZyXEL Communications IES-1248 VDSL-SWITCH User Manual page 226

IES-1248 User's Guide
The following example sets ADSL port 9 to use the voice IGMP filter profile.
ras> switch igmpfilter set 9 voice
33.1.3 IGMP Filter Profile Set Command
Syntax:
switch igmpfilter profile set <name> <index> <startip> <endip>
where
<name>
<index>
<startip>
<endip>
This command configures an IGMP filter profile.
The following example configures an IGMP filter profile named voice with a range of multicast IP addresses
(index 1) from 224.1.1.10 to 224.1.1.44.
ras> switch igmpfilter profile set test1 1 224.1.1.10 224.1.1.44
33.1.4 IGMP Filter Profile Delete Command
Syntax:
switch igmpfilter profile delete <name>
where
<name>
This command removes an IGMP filter profile.
The following example removes the voice IGMP filter profile.
ras> switch igmpfilter profile delete voice
33.1.5 IGMP Filter Profile Show Command
Syntax:
switch igmpfilter profile show [<name>|*]
33-2
= Specify a name to identify the IGMP filter profile (you cannot change the name of
the DEFVAL profile). You can use up to 31 ASCII characters; spaces are not
allowed.
= The number (1~16) to identify a multicast IP address range.
= Type the starting multicast IP address for a range of multicast IP addresses that you
want to belong to the IGMP filter profile.
= Type the ending multicast IP address for a range of IP addresses that you want to
belong to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the Start IP and
End IP fields.
= The name of an IGMP filter profile.
IGMP Filter Commands