ZyXEL Communications IES-1248 VDSL-SWITCH User Manual page 240

IES-1248 User's Guide
sys snmp trusthost set <ip>
where
<ip> =
Use this command to add the host IP address to the list of trusted hosts. If you enter a trusted host, your IES-1248
will only respond to SNMP messages from this address. If you leave the trusted host set to 0.0.0.0 (default), the
IES-1248 will respond to all SNMP messages it receives, regardless of source.
37.2.4 Trap Community Command
Syntax:
sys snmp trapcommunity <community>
where
<community>
Enter this command with the community to set the password.
37.2.5 Trap Destination Set Command
Syntax:
sys snmp trapdst set <ip> [<port>]
where
<ip> =
[<port>] =
Use this command specify the IP address (and port number) of the trap server to which the IES-1248 sends SNMP
traps. If you leave the trap destination set to 0.0.0.0 (default), the IES-1248 will not send any SNMP traps.
37.2.6 Show SNMP Settings Command
Syntax:
sys snmp show
This command displays the current SNMP get community, set community, trap community, trusted hosts and trap
destination settings.
37-2
The IP address of a trusted host.
=
The password sent with each trap to the SNMP manager.
The IP address of the trap server.
The port number upon which the trap server listens for SNMP traps.
The IES-1248 uses the default of 162 if you do not specify a trap port.
SNMP