ZyXEL Communications IES-1248 VDSL-SWITCH User Manual page 192

IES-1248 User's Guide
COMMAND
wdog
monitor
adsl
show
enable
28-4
Table 28-1 Commands
show
clear
show
set
show
enable
disable
vlimit
tlimit
flimit
[portlist]
<portlist>
<msec|0:disable>
<idx> <high> <low>
<idx> <high> <low>
<idx> <high> <low>
DESCRIPTION
Displays the device's logs.
Clears the device's logs.
Displays the current
watchdog firmware protection
feature status and timer.
Sets the watchdog count. 0
turns the watchdog off.
Displays the hardware
monitor's statistics.
Turns the hardware monitor
on.
Turns the hardware monitor
off.
Sets the maximum (<high>)
or minimum (<low>) voltage
at the specified voltage
sensor. You can specify a
voltage with up to three digits
after a decimal point (0.941
for example).
Normal voltage at each
sensor: Idx: 1=1.0v, 2=1.8v,
3=3.3v, 4=2.4v
Sets the maximum (<high>)
or minimum (<low>)
temperature at the specified
temperature sensor. You can
specify a temperature with up
to three digits after a decimal
point (-50.025 for example).
Temperature sensor
locations: Idx: 1=DSL,
2=CPU, 3=power module
Sets the maximum (<high>)
or minimum (<low>) fan revs
per minute (RPM) at the
specified fan (<idx>).
Idx: 1=Fan 1, 2=Fan 2,
3=Fan 3.
Displays the ADSL settings.
Turns on the specified ADSL
ports.
Commands