ZyXEL Communications IES-1248 VDSL-SWITCH User Manual page 114

IES-1248 User's Guide
LABEL
Threshold Specify limits for the individual performance counters. The IES-1248 sends an alarm tram and
generates a syslog entry when one of these thresholds is exceeded. A value of 0 disables the
alarm threshold.
ATU-C These fields are for traffic coming from the subscriber's device to the IES-1248.
ATU-R These fields are for traffic going from the IES-1248 to the subscriber's device.
15 Min LOF This field sets the limit for the number of Loss Of Frame seconds that are permitted to occur within
(sec) 15 minutes.
15 Min LOS This field sets the limit for the number of Loss Of Signal seconds that are permitted to occur within
(sec) 15 minutes.
15 Min LOL This field sets limit for the number of Loss Of Link seconds that are permitted to occur within 15
(sec) minutes.
15 Min LPR This field sets the limit for the number of times a Loss of PoweR (on the ATUR) is permitted to
occur within 15 minutes.
15 Min ES This field sets the limit for the number of Errored Seconds that are permitted to occur within 15
(sec) minutes.
15 Min SE This field sets the limit for the number of Severely Errored seconds that are permitted to occur
(sec) within 15 minutes.
15 Min UA This field sets the limit for the number of UnAvailable seconds that are permitted to occur within 15
(sec) minutes.
15 Min Failed This field sets the limit for the number of failed fast retrains that are permitted within 15 minutes.
Fast Retrain
Init Failure Trap Select Active to trigger an alarm for an initialization failure trap.
Fast Rate Up Specify a rate in kilobits per second (kbps). If a fast mode connection's upstream transmission rate
(bps) increases by more than this number, then a trap is sent.
Fast Rate Specify a rate in kilobits per second (kbps). If a fast mode connection's downstream transmission
Down (bps) rate decreases by more than this number, then a trap is sent.
Interleave Rate Specify a rate in kilobits per second (kbps). If an interleave mode connection's upstream
Up (bps) transmission rate increases by more than this number, then a trap is sent.
Interleave Rate Specify a rate in kilobits per second (kbps). If an interleave mode connection's upstream
Down (bps) transmission rate decreases by more than this number, then a trap is sent.
Alarm profiles After you add an alarm profile, you can click a port number's "-" symbol to map the xDSL port to
with xDSL port that alarm profile. The port's "V" symbol in the alarm profile were it was previously mapped
mapping changes to "-".
Modify Click Modify to edit a profile.
Delete Click Delete to remove a profile.
11-20
Table 11-7 Alarm Profile
DESCRIPTION
ADSL Port Setup