Figure 37-5 Sys Sw Garp Timer Command Example; Figure 37-6 Sys Sw Gvrp Status Command Example; Sys Sw Gvrp Status; Sys Sw Gvrp Enable - ZyXEL Communications Dimension ES-4024 User Manual

Dimension ES-4024 Ethernet Switch
<leave all timer<ms>=
This command sets the switch's GARP timer settings, including the join, leave and leave all timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join message using GARP.
Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all registrations. GARP
timers set declaration timeout values.
The following example sets the Join Timer to 300 milliseconds, the Leave Timer to 800 milliseconds and the Leave
All Timer to 11000 milliseconds.
ES-4024> sys sw garp timer 300 800 11000
37.4.3

sys sw gvrp status

Syntax:
sys sw gvrp status
This command shows the switch's GVRP settings.
An example is shown next.
ES-4024> sys sw gvrp status
GVRP control block status:
gvrpEnable = 1
gvrpPortEnable:
OOOOOOOOOOOOOOOOOOOOOOOOXXXX
37.4.4

sys sw gvrp enable

Syntax:
sys sw gvrp enable
This command turns on GVRP in order to propagate VLAN information beyond the switch.
37.4.5 sys sw gvrp disable
Syntax:
37-4
This sets the duration of the Leave All Period timer for GVRP
in milliseconds. Each port has a single Leave All Period timer.
Leave All Timer must be larger than Leave Timer; the default
is 10000 milliseconds.

Figure 37-5 sys sw garp timer Command Example

Figure 37-6 sys sw gvrp status Command Example

IEEE 802.1Q Tagged VLAN