Table 35-5 Command Summary: Config - ZyXEL Communications Dimension ES-4024 User Manual

Dimension ES-4024 Ethernet Switch
set_igmp_mode
status
tcp
telnet
traceroute
udp
35.2.5 config Command
COMMAND
config save
35-20
Table 35-4 Command Summary: ip
COMMAND
<mode>
ceiling [value]
floor [value]
irtt [value]
kick <tcb>
limit [value]
mss [value]
reset <tcb>
rtt <tcb> <value>
status [tcb] [<interval>]
syndata [on|off]
trace [on|off]
<host> [port]
<host> [ttl] [wait] [queries]
status

Table 35-5 Command Summary: config

You can use the "config save" command to save 802.1Q, STP, Cluster and IP
configuration changes to non-volatile memory (Flash). These changes are effective
after you restart the switch.
However you cannot use "config save" for all other line command configurations.
These are saved in volatile memory (DRAM), so are not effective after you restart
the switch.
Sets mode as IGMP (1) or IGMP
snooping(2).
Displays IP statistic counters.
Sets the TCP maximum round trip
time.
Sets the TCP minimum round trip
time.
Sets the TCP default initial round
trip time.
Drops the TCP connection of the
specified TCP Control Block
(TCB).
Sets a TCP output window limit.
Inputs the TCP Maximum
Segment Size.
Resets the TCP connection of the
specified TCP Control Block
(TCB).
Sets the round trip time for the
TCP control block.
Displays the TCP statistic
counters.
Turns on/off the option to send
data with the SYN packet.
Turns on/off the trace for
debugging.
Telnets to the specified host.
Sends ICMP packets to trace the
route of a remote host.
Displays the UDP status.
DESCRIPTION
DESCRIPTION
Introduction to CLI