ZyXEL Communications Dimension ES-4024 User Manual page 231

applyidx
del
disable
display
set
port
bw
applyidx
del
disable
display
set
trunk
del
disable
display
listView
set
Introduction to CLI
Table 35-2 Command Summary: sys sw
COMMAND
<Class Idx>
<MirrorType=input|output|both>
<Class Idx>
[class idx]
<src port> <src MAC> <src vid>
<dest port> <dest MAC> <dest vid>
<input|output|both>
<port>
<Class Idx> <Max BW>
<Class Idx>
<src port><src mac><src vid><dest
port><dest mac><dest vid><max bw>
<id>
<group><# ports>
Dimension ES-4024 Ethernet Switch
DESCRIPTION
Applies class to mirroring.
Deletes a mirroring class.
Clears current run-time port
mirror settings.
Displays current run-time port
mirror settings.
Creates a mirror rule using
source/destination port, MAC
address and VLAN group
information. "*" means "any".
Sets the direction of mirrored
traffic.
Sets the mirror port (the port
traffic is copied to for analysis).
The following commands relate to
bandwidth control rules.
Bandwidth control means defining
a maximum allowable bandwidth
for traffic flows from specified
source(s) to specified
destination(s).
Apply class to bandwidth control.
Delete a bandwidth control class.
Clears current run-time bandwidth
control rules.
Displays current run-time
bandwidth control rules.
Creates a bandwidth control rule
using source/destination port,
MAC address and VLAN group
information. "*" means "any".
The following commands relate to
trunking. Trunking is the grouping
of physical ports into one logical
higher-capacity link.
Deletes a trunk group.
Clears current run-time trunk
settings.
Displays current run-time trunk
settings.
Displays member list of trunk.
Adds ports to a trunk group.
35-13