Sending Signals To A Flex Bus - Roland V-Mixer VM-C7100 Quick Start Manual

Using Sub Outputs

Sending Signals to a Flex Bus

Now let's assign some signals to a Flex Bus.
You may wish to monitor a Flex Bus directly – this is possible only when the
Flex Bus is set to External (QUICK START: p.44). To monitor the Flex Bus'
signals, select "FBUS 1-12" at "Setting Up a Monitor" (QUICK START: p.34).
fig.119
1
Press [INPUT] or [MULTI IN] to select the type of channel
signals you wish to send to a Flex Bus.
48
3
2 1
4 6 2
Owner's Manual "Setting a
channel's send level and
send point to Flex Buses"
(p.72)