Roland V-Mixer VM-C7100 Quick Start Manual page 45

fig.213
3
Press CURSOR [UP] [DOWN] to select the middle field. Turn
[V2](BUS MODE) to select "EXT", and then press [F2](SET) to
confirm your choice. (Flex Busses 9-12 do not call for this step.)
The Flex Bus is now set to External.
4
Press CURSOR [UP] to move the cursor to the upper field.
5
Turn [V3](MULTI OUT SEL) to select the MULTI OUT
number, and then press [F3](SET) to confirm.
The Flex Bus signals are normally sent out from the corresponding MULTI
OUTs, but can also be routed to the following ASSIGNABLE OUT jacks for
analog output.
• MULTI OUT 17 - ASSIGNABLE OUT 1
• MULTI OUT 18 - ASSIGNABLE OUT 2
• MULTI OUT 19 - ASSIGNABLE OUT 3
• MULTI OUT 20 - ASSIGNABLE OUT 4
• MULTI OUT 21 - ASSIGNABLE OUT 5
• MULTI OUT 22 - ASSIGNABLE OUT 6
• MULTI OUT 23 - ASSIGNABLE OUT 7
• MULTI OUT 24 - ASSIGNABLE OUT 8
6
Press [CH LEVEL].
The Flex Bus' signals are now set to exit the system from the selected MULTI
OUT or ASSIGNABLE OUT jacks.
Using Sub Outputs
If an effect has been
inserted on a Flex Bus, it
may lose its effect when
you switch from "INT" to
"EXT". When this happens,
set the effect's parameters
again (QUICK START:
p.54).
45