Roland V-Mixer VM-C7100 Quick Start Manual page 56

Using On-Board Effects
7
Turn [V2](POSITION) to define the insertion point of the
effect.
The insertion points are as listed below. (Turn [V1] for "MASTER FX" to
select from the following: OFF, MAIN, MONITOR.)
• OFF - No effect
• INPUT PRE EQ - Insert before EQ on Input channels
• INPUT PRE FDR - Insert before fader on Input channels
• MULTI IN PRE EQ - Insert before EQ on Multi In channels
• MULTI IN PRE FDR - Insert before fader on Multi In channels
• SEND/RTN (INT) - Effect receives mono input from a Flex Bus and
produces a stereo effect that can be routed to Main out or Cue bus,
etc. Signal is sent to each effect via its like-numbered Flex Bus.
• INT FBUS - Insert on Flex Bus (Internal mode)
• EXT FBUS - Insert on Flex Bus (External mode)
• MAIN - Insert on Main out
• MONITOR - Insert on Monitor out
examples
• When using an equalizer or compressor on an input signal itself,
insert the effect directly on the Input or Multi In channel.
• When using a reverb for multiple channels, use SEND/RTN (INT) to
create a mono-send/stereo-return loop effect, or insert the effect on a
Flex Bus for a mono-send-return loop effect.
• When using the Total Compressor on your entire mix, insert it on the
Main out.
56
The precise insertion point
of the effects can be seen on
the "Block Diagram" that is
supplied with the
processor.