Roland V-Mixer VM-C7100 Quick Start Manual page 81

Using TASCAM types
The basic steps are mostly the same as formerly mentioned (ADAT), but
there are some exceptions.
• Use a TDIF-1 cable and SYNC cable to connect your TASCAM to
DIF-AT.
(Connect the SYNC cable to the REMOTEIN/SYNC IN socket on the
TASCAM.)
• In Step 3, set "WORD CLOCK SOURCE" to the TASCAM ("MULTI
1-8", "MULTI 9-16", or "MULTI 17-24").
• In Step 5, set "DIF-AT CONTROL TARGET" to "DA-88".
• As formerly mentioned, read the instructions in the manual of the
connected recorder. If you are planning to use several TASCAMs in
synchronization, you must beforehand set the ID of each recorder.
To Send Signals to a FlexBus
1. Press FLEX BUS [1]-[6] – or hold down [SHIFT] to select [7]-[12] – to
select the Flex Bus to which you want to send the signals.
2. Use the channel faders to adjust each channel's send level to the Flex
Bus.
3. Use the [MASTER] fader to adjust the Flex Bus' overall level.
4. Repeat Steps 1-3 to assign signals to other Flex Busses.
8 Track Digital Recording
The 8 Track Digital Recording EZ Routing template sends your signals to
Flex Busses routed to an R-BUS, a stream of digital data containing eight
separate channels of digital audio. Each of these R-BUS channels is routed
to the corresponding track of an R-BUS connected 8 track digital recorder.
R-BUS 1: Electric Bass (Ch 14)
R-BUS 2: Lead Guitar (Ch 15)
R-BUS 3: Acoustic Guitar (Ch 16)
R-BUS 4: Chorus 1 (Ch 17)
R-BUS 5: Chorus 2 (Ch 18)
R-BUS 6: Chorus 3 (Ch 19)
R-BUS 7: Lead Vocal (Ch 20)
R-BUS 8: Lead Vocal spare track (Ch 20)
The 8 Track Mixdown Procedure
During mixdown, you can use MTC to play back tracks recorded on your 8
track digital recorder while your MIDI sequencer runs in sync with the
system. Control the MIDI-sequenced materials at [INPUT] channels, and the
live elements on the digital recorder at [MULTI IN] channels.
Using EZ Routing Templates
Owner's Manual "Setting a
channel's send level and
send point to Flex Buses"
(p.72)
81