Using On-Board Effects - Roland V-Mixer VM-C7100 Quick Start Manual

Using On-Board Effects

In this system, there are two internal effects available to the Input and Multi
In channels, and an additional effect provided for the Main out and
monitors. In addition, you can install optional VS8F-2 Effects Expansion
Boards – sold separately – allowing the system to produce up to nine effects
simultaneously from a single mixing processor (see list below).
• FX-1, FX-2 - Pre-installed
• FX-3, FX-4 - VS8F-2 (optional) installed to EFFECT A inside the
processor
• FX-5, FX-6 - VS8F-2 (optional) installed to EFFECT B inside the
processor
• FX-7, FX-8 - VS8F-2 (optional) installed to EFFECT C inside the
processor
• MASTER FX - Pre-installed. Only for MASTER OUT and monitors.
On using the effects, the following steps will be necessary.
1. Make a decision as to where you wish to insert an effect.
You may insert the effect on a Flex Bus to create a send-return loop effect,
or directly on an input channel.
2. To create a send-return loop effect, send the signals to which you wish to
apply the effect to a Flex Bus that is routed to the Main out.
3. Select the desired effect.
Each input also has its own feedback-type delay that produces a delay effect
without using the on-board effect.
Now, let's add some effects to your signals.
50
Read OWNER'S MANUAL
for the Processor
"Installing Effects
Processors (VS8F-2)" (p.13)
to learn about the
installation of the VS8F-2.