Roland V-Mixer VM-C7100 Quick Start Manual page 47

2
Hold down [CH EDIT] on the channel strip numerically
corresponding to the Flex Bus you wish to edit, and press
[MAIN/CUE].
The "MAIN/CUE" editing page on the "CH EDIT" display appears.
fig.213
3
Press CURSOR [UP] [DOWN] to select the middle field. Turn
[V2](BUS MODE) to select "INT", and then press [F2](SET) to
confirm your choice.
The Flex Bus signals are now set to Internal.
4
Press CURSOR [DOWN] to move the cursor to the lower field.
5
Turn [V1](MAIN LEVEL) to adjust the Main out send level.
The Flex Bus' signals are now routed into the Main out mix.
Using Sub Outputs
47