Ricoh Aficio 2232C User Manual page 445

Problem
When using Make sure the application's paper size and orientation settings match those
Windows of the printer driver.
95/98/Me/2000/
If a different paper size and orientation are set, select the same size and ori-
XP, Windows
entation.
Server 2003, or
Windows NT 4.0,
either combined
printing or book-
let print does not
come out as ex-
pected.
When using
Windows
95/98/Me/2000/
XP, Windows
Server 2003, or
Windows NT 4.0,
Auto Reduce/En-
large print does
not come out as
expected.
A print instruc- User code management may have been set. Ask the administrator about
tion was issued valid user codes. To print, the user code must be entered from the printer
from the compu- driver.
ter, but printing
did not start.
The print job is not Even when the machine is offline, printing is performed when [Job accept-
canceled even ance priority] has been set in [Parallel Interface] in the [Interface Settings] in th-
when the machine eSystem Settings menu. Change the setting of Signal Control to Printer
is switched to of- priority.
fline status.
See "User Tools (System Settings)", General Settings Guide.
Photo images are Some applications reduce print resolution.
coarse.
Fine dot pattern Make the following settings with the printer driver:
does not print.
• Change the [Dithering:] setting on the [Image Adjustments] tab in the
See the printer driver Help.
Images are cut off, You may be using paper smaller than the size selected in the application.
or excess is print- Use the same size paper as that selected in the application. If you cannot
ed. load paper of the correct size, use the reduction function to reduce the im-
age, and then print.
See the printer driver Help.
Causes and Solutions
[Change User Settings...] dialog box on the [Print Quality] tab in the RPCS™
printer driver.
Note
❒ To enable [Change User Settings...], select the [User settings] check box.
Other Printing Problems
4
35