Nortel CC MIS Getting Started Manual page 84

CC MIS
CC MIS
Alarms (SNMP)
as indicated by the label on the button in the upper right corner of the win-
dow. The two modes of operation are modify and add. When the window is
entered, the initial mode is set to the add (if there are no alarm definitions
currently defined). Otherwise, it is set to the modify mode.
Use the steps below to add an alarm definition.
Note: For more information concerning adding or modifying an alarm def-
inition, select the Help / Window option.
steps
Creating an Alarm definition
Use the steps below to modify an existing alarm definition.
steps
Modifying an Alarm definition
Page 8-4
1. From the alarm window, select Options / Add
or click on the Add button.
2. Enter information into the Alarm Definition window.
3. Click on the Add button to send the definition to the
database. The definition should now be listed in the
list of alarm definitions.
1. From the alarm window, select an existing alarm
definition from the list of Alarm Definitions.
2. Make the desired changes.
3. Click on the Modify button to send the changes to
the database.
Note: To cancel the changes, click on the Revert
button (or select Edit/Revert) before you click the Modify
button.
Release 5.2
CC MIS Getting Started Guide (297-2671-175)