Configuration Control; Introduction; Networked Cc Mis; Accessing Configuration Control Functions - Nortel CC MIS Getting Started Manual

Release 5.2

Configuration Control

Introduction

Configuration control allows you to view and adjust parameters inside the
ACD switch that relate to operating functions such as traffic control and
staffing. CC MIS provides two modes of security that allows supervisors to
have control over access to Configuration Control screens and system
administration: Privilege Level Definition and Scope Definition.

Networked CC MIS

When the Networking feature is enabled, the Configuration Control screens
contain a Node field and the Insert dialogs allow for Node selection. The
Node field is used to identify the node of the position or group. The node
selection function allows you to select a node, then insert positions or
groups listed under the node selected.
Note: The APR feature is not available for Network Access Partitions.
Therefore Configuration Control screens that display the Node field will not
display the APR fields.

Accessing configuration control functions

The CC MIS configuration control (load management) functions are access-
ed from the Config pulldown menu. The Config menu is selected on the
CC MIS Main window.
steps
Accessing the Config menu
CC MIS Getting Started Guide (297-2671-175)
1. From the CC MIS Main window, select Config.
2. The Config pulldown menu is displayed.
Select the desired function from the menu.
CC MIS
CC MIS
Configuration Control
10
10
Page 10-1