Troubleshooting - LG LST-4600A Installation And Setup Manual

Troubleshooting

Operation Notes
Disconnect the Clone from the LG Integrator Box or TV
after you are finished; automatically switching it off. The
real-time clock continues to run when the main circuits
are switched off.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the program-
mer behaves strangely after a static shock, use a paper
clip or similar instrument inserted through the small hole
marked "RESET" to activate the internal reset switch
and restore normal operation.
After a reset, check the real-time clock setting. It may be
necessary to reset the Clone Programmer clock from a
TV containing the correct time.
Clone Programmer Troubleshooting
Problem
Clone Programmer
LED does not blink.
Clone menu hard
to read.
No time set.
Menu items 7-8 not on
clone selection menu.
Master and Other Integ.-Box/TVs
Cloning did not work.
Clone time disappeared.
New Setup not present.
Clone operates but
operation is erratic.
• When cloning operations are complete, just unplug the LT2000 from the Integ.-Box/TV.
• If the Integ.-Box/TV does not display a picture (blank screen) after a few seconds, just change channels.
Possible Cause(s)
• MPI cord not connected.
• Integ.-Box/TV not turned
on
• Weak batteries.
• Weak signal.
• No time on master Integ.-
Box/TV not turned on.
• Not necessary.
• Procedure interrupted.
• Different Integ.-Box/TVs
models.
• Batteries were removed.
• Integ.-Box/TV not reset.
• Integ.-Box/TV configured
for OCC System.
Possible Solution(s)
- Connect MPI cord.
- Integ.-Box/TV not turned on.- must be on for clone
to work.
- Install 4 fresh AA high-quality alkaline batteries.
- Connect Integ.-Box/TV not turned on.- to a reliable
signal source.
- Set time on master Integ.-Box/TV, copy time to
Clone Programmer.
- Channel Labels already cloned; if they were on
master Integ.-Box/TV.
- Wait until procedure complete message is dis-
played.
- Cloning is only possible with identical model Integ.-
Box/TVs.
- Batteries must remain installed to retain time set-
tings.
- Disconnect newly-cloned Integ.-Box/TV from power
for 5 seconds.
- Configure Integ.-Box/TV for cloning in OCC
Systems.
Contact On Command Corporation.
Master and Other Integ.-Box/TVs
49