Cable Service Signal Reception Setup
If the signal source is from a cable source with or without a cable box, connect the cable service to the Integrator
Box system as shown below.
Integrator Box Connection Panel
ote
If using a Cable Box to select channels, be sure to set the Cable Box channel output switch to channel 3 or 4 and
also tune the Integrator box to channel 3 or 4; to see the channel that the Cable Box is tuned to.
Cable TV
Wall Jack
RF Coaxial Wire
(75 ohm)
RF Coaxial Wire
(75 ohm)
Cable TV
Wall Jack
Cable Box
In
Output
Out
Switch
3 4
19