Baud Rate - Kyocera FS FS-1920 Operation Manual

6
Press the > key. Each time the
and current setting change as shown below.
>Baud Rate
9600
>Data Bits
8
>Stop Bits
1
>Parity
None
>Protocol
DTR(pos.)&XON
7
Display the setting item to be changed and press the ENTER key. A
question mark (?) appears.
The following example explains how to change the baud rate. The
settings for other items can be changed in a similar manner.
>Baud Rate
?
8
Press the
changes as shown below.
The baud rate can be selected from 1200, 2400, 4800, 9600 (default),
19200, 38400, 57600, and 115200.
Some computers may not be compatible with a baud rate of 115200 bps.
If you set the baud rate to 115200 and communication problems occur,
lower the baud rate.
Note
9
Display the desired baud rate and press the ENTER key.
10
Press the MENU key. The message display returns to Ready.
9600
or key to display the desired setting. The setting
1-77
or key is pressed, the setting item
Definable baud rates: 1200, 2400, 4800,
9600 (default), 19200, 38400, 57600,
115200
Definable data bits: 7, 8 (default)
Definable stop bits: 1 (default), 2
Definable parity: None (default), Odd, Even,
Ignore
Definable protocol: DTR(pos.)&XON
(default), DTR(positive), DTR
(negative), XON/XOFF, ETX/ACK
Interface