Kurzweil K2600 Musician's Manual page 520

DSP Functions
The DSP Functions
Upper and Lower Amp (AMP U AMP L)
This two-stage function is similar to the AMP function described above, but it appears in
algorithms that have split the signal to two wires and has sent them through different DSP
functions in the F2 and F3 blocks. This function enables you to set the Þnal amplitude
independently for each wire, and keeps the two signals separate at its output, giving you added
ßexibility for mixing and panning. Like the AMP function, UPPER AND LOWER AMP always
appears as the last block in an algorithm. Since itÕs a two-stage function, it has two control-input
pages. F3 selects the control-input page for the lower wire, and F4 the control-input page for the
upper wire.
EditProg:F3|AMP(AMP|U/L)|||<>Layer:1/1||
Adjust:0dB||||||||||Src1||:OFF||||||||||
||||||||||||||||||||Depth|:0dB||||||||||
||||||||||||||||||||Src2||:OFF||||||||||
KeyTrk:|0.00dB/key||DptCtl:OFF||||||||||
VelTrk:0dB||||||||||MinDpt:0dB||||||||||
Pad|||:0dB||||||||||MaxDpt:0dB||||||||||
<more||F1|||||F2|||||F3|AMP|F4|AMP|more>
Parameter
Adjust
Key Tracking
Velocity Tracking
Pad
Source 1
Source 1 Depth
Source 2
Source 2 Depth Control
Minimum Depth, Source 2
Maximum Depth, Source 2
Balance and Amp (BAL AMP)
This function has a two-wire input and a two-wire output. The parameters on its control-input
page affect the amount of gain applied to each wire between input and output. A value of 0%
applies equal gain to both the upper and lower wires; at a value of 100% only the upper wireÕs
sound will be audible, at -100%, only the lower wireÕs sound will be audible. This works like the
balance control on any stereo system; as the gain increases for one wire, it decreases for the
16-36
Range of Values
-96 to 48 dB
± 2.00 dB per key
± 96 dB
0, 6, 12, 18 dB
Control Source list
± 96 dB
Control Source list
Control Source list
± 96 dB
± 96 dB