Kurzweil K2600 Musician's Manual page 519

PANNER
This single-stage function converts a single wire at its input into a double wire at its output,
splitting the signal between an ÒupperÓ and ÒlowerÓ wire. This creates a double-output
algorithm, as discussed on page 6-31. The parameters on the PANNER page enable you to
modify the signalÕs routing through the upper and lower wires. By itself the PANNER doesnÕt
change the pan position of the sound. It just deÞnes what percentage of the currently selected
layerÕs sound goes to each wire. When you select one of these double-output algorithms, the
OUTPUT page for the layer changes to enable you to make pan settings for each wire
independently. So when you use the PANNER function, youÕll also want to adjust the Pan
parameters on the OUTPUT page, setting the upper wireÕs pan fully right, and the lower wireÕs
pan fully left. This will enable you to hear the effect of the PANNER function.
The PANNER function is available only in algorithms 2, 13, 24, and 26, and always appears in
the block before the Þnal AMP function. Consequently, it will always be selected with the F3 soft
button, which is labeled F3 POS (position).
EditProg:F3|POS(PANNER)||||<>Layer:1/1||
Adjust:0%|||||||||||Src1||:OFF||||||||||
||||||||||||||||||||Depth|:0%|||||||||||
||||||||||||||||||||Src2||:OFF||||||||||
KeyTrk:|0.0%key|||||DptCtl:OFF||||||||||
VelTrk:0%|||||||||||MinDpt:0%|||||||||||
Pad|||:0dB||||||||||MaxDpt:0%|||||||||||
<more||F1|||||F2|||||F3|POS|F4|AMP|more>
Parameter
Adjust
Key Tracking
Velocity Tracking
Pad
Source 1
Source 1 Depth
Source 2
Source 2 Depth Control
Minimum Depth, Source 2
Maximum Depth, Source 2
The Adjust parameter sets the initial routing of the layer to the upper or lower wire. -100% is the
lower, and 100% is the upper. The KeyTrk parameter lets you shift the layerÕs sound from one
wire to the other based on the MIDI key number of each note. For positive values of KeyTrk, the
higher above Middle C, the more sound goes to the upper wire.
The remaining parameters have ranges from -200% to 200%. This lets you start with a sound
thatÕs fully on the lower wire, for example, and shift it completely to the upper wire. The VelTrk
parameter shifts notes between wires based on the attack velocity of each note. For positive
values, the higher the attack velocity, the more sound goes to the upper wire. The Src1 and Src2
parameters let you assign controls to reroute the sound relative to the initial routing. Setting
their depth parameters to positive values will shift the sound to the upper wire when the
controls assigned to them approach their maximum values.
Range of Values
± 100%
± 16% per key
± 200%
0, 6, 12, 18 dB
Control Source list
± 200%
Control Source list
Control Source list
± 200%
± 200%
DSP Functions
The DSP Functions
16-35