Kurzweil K2600 Musician's Manual page 494

DSP Functions
The DSP Functions
are high-amplitude partials, the signal may clip. The Pad parameter on the F1 FRQ page will
reduce the clipping, but thereÕs no harm in keeping it if you like the sound.
EditProg:F2|RES(2P|LOPASS)|<>Layer:1/1||
Adjust:0.0dB||||||| |Src1||:OFF||||||||||
||||||||||||||||||||Depth|:|0.0dB|||||||
||||||||||||||||||||Src2||:OFF||||||||||
KeyTrk:|0.00dB/key||DptCtl:OFF||||||||||
VelTrk:|0.0dB|||||||MinDpt:|0.0dB|||||||
|||||| | |||||| | |||||| M axDpt: | 0.0dB| | |||||
<more| | F1|FRQ | F2|RES | F3|||| | F4|AMP | more>
Parameter
Adjust
Key Tracking
Velocity Tracking
Source 1
Source 1 Depth
Source 2
Source 2 Depth Control
Minimum Depth, Source 2
Maximum Depth, Source 2
Two-pole Lowpass Filter, -6 dB Resonance (LOPAS2)
Using this Þlter is the same as using two one-pole lowpass Þlters in successive algorithm blocks.
Since its resonance is Þxed at -6 dB, itÕs also the same as using 2POLE LOWPASS with the
resonance set to -6 dB. YouÕd use this Þlter when you want a 12 dB per octave rolloff but donÕt
need to set a resonance level. This would leave you free to use another DSP function in the
algorithm, since itÕs a one-stage function.
16-10
Range of Values
-12 to +48 dB
± 2.00 dB per key
-30 to +60 dB
Control Source list
-30 to +60 dB
Control Source list
Control Source list
-30 to +60 dB
-30 to +60 dB
Frequency in Hertz
10 100
0
-10
C 4
-20
-30
-40
-50
Resonance = 0 dB;
-60
cutoff frequency
from C 4 to C 10
-70
-80
1000 10000
C 10
100000