Renaming Files - Kurzweil K2600 Musician's Manual

The move operation begins when you press either Current or SetDir.
If the default destination directory is the same as the source directory, the K2600 will skip the
Use default directory? question and instead go right to the Select dest dir dialog.
A good way to organize Þles into subdirectories is by using the Move command. First, create the
subdirectories you need, using the NewDir function. Then, use multiple Þle selection to select
the Þles to be grouped into a particular subdirectory. The Þles can be moved to their new
location in one operation.
For each Þle that is moved, you will see a conÞrmation message:
\ATOMTOM.K26|moved|to|||||||||||||||||||
\DRUMHITS\ATOMTOM.K26|||||||||||||||||||
Note the following:
¥ You can select multiple Þles for moving within a directory. However, you cannot move Þles
from more than one directory at a time. If you select any Þles and then switch to another
directory, the Þles you had chosen will be deselected.
¥ If you are moving a directory, you cannot move it in to a subdirectory of itself.
¥ If the source and destination directories are the same, the Þle will not be moved, and an
error message such as the one below is displayed. This would happen if you pressed
Current above.
¥ The same message will be displayed if there is a Þle in the destination directory with the
same name as the Þle to be moved.
File|\ATOMTOM.K26|not|moved.||||||||||||

Renaming Files

Press the Rename soft button (from Disk mode) to rename Þles or directories without loading
them. When you press Rename, the K2600 will prompt you to select the Þle to be changed, by
showing you a list of the Þles found on the current disk.
When youÕve selected the Þle to be renamed, press OK, and the K2600 will ask you to enter the
new Þlename. When youÕve done this, press OK, and the Þlename will be changed.
Dir:\||||||||||||Sel:0/1|||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||File|to|rename:FILE9876|.K26|||2048K||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Total:2048K||||||||||||||||||||||||||||
||||||||Root||Parent||Open|||OK|||Cancel
This function can be used to change only the 8-character Þlename, not the extension. When you
press Rename, the File List dialog is displayed and you can navigate through the directories to
choose the Þle or directory you wish to rename. Unlike the other disk functions that use the File
List dialog, you will not see the Select soft button. This is because you can rename only one Þle
Disk Mode
Disk Utilities
13-65