Kurzweil K2600 Musician's Manual page 193

Sends
The third and fourth blocks determine the destinations of the Input A signal: each block can be
set to route the signal to any of the four insert FXBuses, or to None. You cannot, however, set
both blocks to the same destination.
The Lvl control is the FXBus send; it sets the level of the signal to the FXBus above it. In this
input section, the level is backed off 6.0 dB, to compensate for the treble boost in the equalizer, so
that the signal doesnÕt overload the FXBus.
Pan determines the position of the signal respective to the left and right sides. Width (which is
not shown when you are using mono inputs) determines how much the left and right sidesÕ
signals will be separated or blended.
The AUXFX Page
Press the AUXFX soft button. This page appears:
EditStudio:AUXFX|Size:3|Free:0||||||||||
||Aux||204*Big|Chamber|||||||||||Mix
|||Wet/Dry|||:58%wet||||||||||||Lvl:0.0dB
|||Out|Gain||:1.5dB|||||||||||||Bal:0%
<more||INPUT||FXBUS||AUXFX||OUTPUT|more>
This is the Global AUXFX page, and shows us what is happening on the Auxiliary effects bus.
The Aux bus is a second processor, which follows the four insert FXBuses. It has its own
FX preset, with bus overrides, and level and balance controls to feed it into the Mix bus. It
doesnÕt share PAUs with the FXBuses; it has three PAUs of its own, and consequently doesnÕt
have an Allocation parameter. The Aux bus can be routed all by itself to an output, as weÕll see.
In this studio, the Aux bus contains a chamber reverb.
The OUTPUT Page
Press the OUTPUT soft button.
EditStudio:OUTPUT||||||||||||||||||||||||
Mix|Lvl:0.0dB||||||Output|A:Mix
Mix|Bal:0%|||||||||Output|B:FXBus1
|||||||||||||||||||Output|C:Off
|||||||||||||||||||Output|D:Off
<more||INPUT||FXBUS|AUXFX||OUTPUT||more>||
The OUTPUT page is the interface to the real world. It determines which of the signals going
through the various effects buses show up at the K2600Õs four sets of physical outputs: A, B, C,
and D. These four outputs, all stereo, are both analog and digital (through the KDS bus). Output
A also goes to the K2600Õs AES/EBU digital output.
Basic Effects Mode
A Tour of Effects Mode
9-15