Filters - Kurzweil K2600 Musician's Manual

Advanced KDFX
Using the Algorithms
sample. At low values, the buzz starts at high frequencies and drops slowly, while at high values
the buzz starts at a lower pitch and drops rapidly. Range is 0.0 to 40.0 samples.
Contour controls the overall shape of the reverb. When set to a high value, sounds passed
through the reverb start at a high level and slowly decay. As the control value is reduced, it takes
more time for the effect to build up before decaying. At a value of around 34, the reverb behaves
like a reverse reverb, building up to a hit. When it is set to 0, the algorithm acts like a simple
delay. Range is 0 to 100%.

Filters

There are four types of Resonant Filter algorithms in KDFX.
Resonant Filter
Filter Type (FiltType) can be Lowpass, Highpass, Bandpass, or Notch (band-limit).
Frequency (Freq) is the resonant frequency of the Þlter. Its range is 58 to 8372 Hz.
Resonance is the resonance of the Þlter, adjustable from 0 to 50 dB.
Envelope Filter
Envelope Filter is a resonant Þlter whose center frequency can be made to vary according to the
level of the incoming signal.
Filter Type can be Lowpass, Highpass, Bandpass, or Notch (band-limit).
Min Freq is the minimum resonant frequency of the Þlter, that is, the Þlter frequency when the
input gain is below the triggering threshold. Its range is 58 to 8372 Hz.
Sweep determines how far the resonant frequency moves when the input level increases. At
positive levels it moves up in pitch, and at negative levels it moves down. The highest possible
resonant frequency is 8372 Hz,; the lowest is 0 Hz. This parameterÕs range is -100% to +100%.
Resonance is the resonance of the Þlter, adjustable from 0 to 50 dB.
Atk Rate adjusts the upward slew of the attack portion of the envelope detector. Range is 0 to
300.0 dB/sec.
Rel Rate adjusts the downward slew of the release portion. Range is 0 to 300.0 dB/sec.
Smooth Rate slows down the envelope follower. If it is set to a lower rate than Atk Rate or Rel
Rate, it can dominate those parameters. Range is 0 to 300.0 dB/sec.
Trig Filt
The Triggered Filter is a sweeping resonant Þlter that triggers when a certain input threshold is
reached, and then follows its own envelope, consisting of an instantaneous attack and an
exponential release, rather than the envelope of the input signal.
Max Freq is the resonant frequency of the Þlter at the peak of the internal envelope. It can be set
lower than Min Freq (above), in which case the Þlter will sweep downwards, then back up.
Range is 58 to 8372 Hz.
Trigger is the input-signal threshold at which the envelope detector triggers. Range is -79 to
0 dB.
15-43