Kurzweil K2600 Musician's Manual page 408

Sampling and Sample Editing
Editing Samples
The Truncate function will automatically reset the Start (S) and End (E) points of the sample.
This can be quicker than trimming the sample manually on the TRIM page.
Use the Start and End parameters to select a speciÞc sample range. Set the Thresh parameter
from -96 to 0dB to set the noise ßoor. When you press the Go soft button, the K2600 will search
inward from the start and end points you set, until it Þnds the Þrst sample that exceeds the noise
ßoor. Everything outside the range will be left out. YouÕll want to experiment with different
thresholds to Þnd the noise ßoor that suits each sample you truncate. If the new End point is
inside the current loop point, the loop will be disabled.
When you press the Go soft button, youÕll be prompted ÒKeep this change?Ó Unlike the other
DSP functions, answering Yes does not bring up the Save dialog. It registers the new Start and
End positions as the Start (S) and End (E) points (as set on the TRIM or LOOP page). In fact, you
can go to either of these pages to readjust the S and E points if you want to include more of the
sample. To save the new S and E points, press the Done soft button (if necessary) to return to the
SampleMode page, then press either the Save soft button, or Exit.
3 Volume Adjust
F:VolAdjust||Start:1.019||||End:5.126|||
VolAdj:0dB||||||||||||||||||||||||||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
Use this function for a uniform cut or boost in the amplitude of the selected sample segment.
This function will clip samples if you adjust the volume too high. This wonÕt hurt the K2600, and
you may Þnd it useful in some applications. In any case, youÕll need to choose your start and
end points carefully, if you want to avoid abrupt changes in volume.
When youÕve selected the range to be adjusted, select the VolAdjust parameter with the cursor
buttons, and use the Alpha Wheel to adjust the volume of the selected range. You can cut/boost
the volume from -96 to 96 dB.
4 Clear
F:Clear||||||Start:0.000||||End:6.000|||
||||||||||||||||||||||||||||||||||||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
14-22