Kurzweil K2600 Musician's Manual page 411

Sampling and Sample Editing
Editing Samples
8 Insert Zero
F:InsertZero|Start:0.000||||End:6.000|||
Length:0.000||||||||||||||||||||||||||||
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
This function will insert a period of silence of any length into the selected sample range. This
function is equivalent to splicing a section of blank tape into an existing segment of recorded
tape. ItÕs useful for creating a delay on the start of a sample, or creating a silent spot in the
middle or at the end of the sample. Adjust the Start parameter to determine the point at which
the period of silence will begin. Adjust the Length parameter to specify how long the silence will
be. The End parameter has no effect for this function.
9 Mix
F:Mix||||||||Start:0.000||||End:6.000|||
In:0.000|||Out:0.000|||Vol:0dB|||Cur:LIN
VVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVVV
-6dB>|||||||||||||||||||||||||||||||||||
****************************************
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|Cut||||Copy||Paste||Samp2|||Go||||Done|
With this function you select a segment from Sample 2, and merge it with the selected segment
from Sample 1, beginning at the point you set with the Start parameter. This is equivalent to
mixing two audio signals through a mixing board. If the Sample 2 segment is longer than the
segment from the Start (S) to the End(E) of Sample 1, the resulting sample will be longer than the
original Sample 1.
Use the In and Out parameters to specify the length of time it takes Sample 2 to reach full
amplitude and to fade to silence. The Curve parameter selects the curve of the fades. The
available values are LIN, EXP, COS, EQL, and MIX. These curves are described on page 14-34.
The Volume Adjust parameter will cut or boost the amplitude of Sample 2 from -96 to 96 dB
before merging.
If the sample rate of Sample 2 is different from that of Sample 1, the K2600 will alert you that the
sample rates differ. If you mix samples with different rates, youÕll hear a pitch shift in the mixed
sample. If you donÕt want this pitch shift, use the Resample function to match the sample rates
of the two samples before mixing.
14-25