Kurzweil K2600 Musician's Manual page 366

Disk Mode
Macros
Use the Drive parameter to change the Disk ID for the selected macro entries. This is where you
would set the entriesÕ Disk IDs to be UnspeciÞed or Library. If you increment the Modify
parameter, the display switches to let you modify bank and mode information:
Modify|Macro|Entries||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Modify:Bank/Mode||||||||||||||||||||||||
Bank||:200's||||||Mode:Fill|||||||||||||
||||||||||||||||||||||||||||||||||||||||
4|entries|selected.|||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||Delete||OK|||Cancel
The initial settings of the parameters on these pages are always taken from the lowest-indexed
macro entry that is selected on the MACRO page. In addition, every time you return to the
ÒModify Macro EntriesÓ page, both the Modify parameter and the highlighted value will be the
same.
Pressing OK will set all of the selected macro entries to have Disk ID or bank and mode settings
according to the parameters set up on this page. The display will return to the MACRO page
with the same entries still selected. Any modiÞcations to the parameters will be visibly
apparent. Selecting multiple entries for editing allows you to change those entries in a uniform
way. In our example above, you could change the macro so that all the Þles were loaded into a
single bank, instead of the separate banks they had previously been loaded to.
Press Delete to remove the macro entries from the Macro table. You will see the display:
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Delete|macro|entries?|||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||||||||||Yes||||No||
If you answer Yes, the display returns to the MACRO page and all of the previously selected
entries will be gone from the list. If you answer No, the display will return to the Modify Macro
Entries dialog.
Pressing Cancel in the Modify Macro Entries dialog will return to the MACRO page with
everything that was selected still selected, but with no parameter changes made to any macro
entries.
Here are the parameter values for Modify Macro Entries:
Parameter
Modify
Drive
Bank
Mode
13-56
Values
Drive, Bank/Mode
Floppy, SCSI 0–SCSI 7, Unspecified, Library
000s–900s, Everything
Append, Merge, Fill, Overwrite, OvFill