Kurzweil K2600 Musician's Manual page 214

MIDI Mode
The RECEIVE Page
This enables you to receive the messages listed in the Þrst column of Table 10-1 from a MIDI
source, and remap them to whatever values are available for the parameters listed in the second
column. The third column lists the Studio-editor page where each parameter appears. Note that
when the Large Ribbon is conÞgured in one section, you cannot remap incoming MIDI
Controller messages through it.
The MIDI Controller number
received from your MIDI
source...
Mono Pressure
Modulation (01)
Breath (02)
Foot (04)
Data (06)
Ctl A (16)
Ctl B (17)
Ctl C (18)
Ctl D (19)
MIDI 20
MIDI 22
MIDI 23
MIDI 24
MIDI 25
MIDI 26
MIDI 27
MIDI 28
Sustain (64)
Sostenuto (66)
Soft Pedal (67)
Legato Switch (68)
Freeze Pedal (69)
MIDI 70 (70)
Table 10-1
HereÕs a more speciÞc example. Suppose your MIDI controller transmits on MIDI Channel 1,
and youÕve set the LocalKbdCh parameter to a value of 1. YouÕve also set the MWhl parameter
on the WHEEL page in the Setup Editor to a value of Volume (MIDI 07) for each setup zone.
Then youÕve selected a setup that uses MIDI Channels 1, 2, and 3. When you send a Modulation
message (MIDI 01) from the MIDI controller, youÕll affect the K2600Õs volume (unless the
VolLock parameter for Channel 1 is on), and the K2600 will send a Volume message to its
MIDI Out port, on Channels 1, 2, and 3.
10-8
...gets sent to the MIDI
Controller number assigned as
the value for this parameter...
Press
ModWhl
CPedal2
CPedal1
Slider A
Small Ribbon Position
Small Ribbon Pressure
Large Ribbon Section 1
Large Ribbon Section 2
Large Ribbon Section 3
Slider B
Slider C
Slider D
Slider E
Slider F
Slider G
Slider H
FtSw1
FtSw2
FtSw3
FtSw4
Switch 1
Switch 2
Controller Remapping Via Local Keyboard Channel
...which is on this page in the
Studio Editor
PRESS
WHEEL
CPEDAL
CPEDAL
SLIDER
RIBBON
RIBBON
RIBBON
RIBBON
RIBBON
SLIDER
SLIDER
SLIDER
SLID/2
SLID/2
SLID/2
SLID/2
FOOTSW
FOOTSW
FOOTSW
FOOTSW
SWITCH
SWITCH