Installations And Settings; I Opening The Transceiver Case; Voice Synthesizer Unit; D Operation - Icom IC-703 Instruction Manual

OPTION UNIT INSTALLATIONS AND SETTINGS

I Opening the transceiver case

To remove the transceiver case unscrew the 18 screws
(5 in the top panel, 5 in the bottom panel, 8 in the side
panels: 4 pieces each) as shown in the diagram below.
I UT-102

VOICE SYNTHESIZER UNIT

The UT-102 announces the accessed band's fre-
quency, mode, etc. (S-meter level can also be an-
nounced—p. 82) in a clear, electronically generated
voice, in English (or Japanese).
q Remove the top cover as shown above.
w Connect the UT-102 as shown in the diagram at
right (label side up).
e Replace the top cover.
D D Operation
q Select the desired announcing condition, such as
speed, language, contents, in initial set mode.
(p. 82)
w Push [LOCK] for 1 sec. (until "zero" is announced)
to announces the selected contents.
[LOCK]
Caution:
Disconnect the DC power cable from
the transceiver before performing any work on the
transceiver.
Top cover
Speaker
cable
Bottom cover
R7205
MAIN unit
✔ Adjusting the announcing audio level
➥ Adjust the R7205 on the MAIN unit .
15
UT-102
14
15
86