I Installation; D Single Body Mounting; D Stand; D Front Panel Separation - Icom IC-703 Instruction Manual

I Installation

D Single body mounting

MB-62
(optional)
Supplied with
the MB-62*
Flat washer
*CAUTION: Non-supplied screws (longer than 8 mm)
may damage the internal units.

D Front panel separation

q While pulling the panel release button towards you,
slide the front panel to the right (fig. 1).
w Attach the optional OPC-581 to the main body and
tighten the supplied screw as in fig. 2.
e Attach the other end of the OPC-581 to the de-
tached front panel as in fig. 3.
fig. 1
Latch

D Front panel mounting

q Attach the MB-63 to a flat surface using the two
supplied screws (fig. 1).
w Fix the detached front panel to the MB-63 as illus-
trated in fig. 2.
BE CAREFUL of the orientation of the MB-63, oth-
erwise, the front panel may become attached in the
opposite direction.

D Stand

Spring washer
Nut
fig. 2
Separation cable
INSTALLATION AND CONNECTIONS
To raise the stand:
With the transceiver upside down, pull the stand to-
wards the rear panel and then upwards, as illus-
trated below.
then up
Pull back
CAUTION:
NEVER detach/attach the front panel
when connecting the DC power supply (or battery).
Make sure the disconnecting DC power cable from
the [13.8 V] receptacle on the transceiver rear
panel.
fig. 3
fig. 1
2
Separation cable
fig. 2
2
12