Aggregating Ports - HP Blade bc1500 User Manual

Configuring Interfaces
4. Modify the fields.
5. Click

Aggregating Ports

Link Aggregation optimizes port usage by linking a group of ports together to form a single
LAG. Aggregating ports multiplies the bandwidth between the devices, increases port flexibility,
and provides link redundancy.
The device supports both static LAGs and Link Aggregation Control Protocol (LACP) LAGs.
LACP LAGs negotiate aggregating port links with other LACP ports located on a different
device. If the other device ports are also LACP ports, the devices establish a LAG between them.
Ensure the following:
■
All ports within a LAG must be the same media type.
■
A VLAN is not configured on the port.
■
The port is not assigned to a different LAG.
■
Auto negotiation mode is not configured on the port.
■
The port is in full duplex mode.
■
All ports in the LAG have the same ingress filtering and tagged modes.
■
All ports in the LAG have the same back pressure and flow control modes.
■
All ports in the LAG have the same priority.
■
All ports in the LAG have the same transceiver type.
■
The device supports up to eight LAGs and eight ports in each LAG.
■
Ports can be configured as LACP ports, only if the ports are not part of a previously
configured LAG.
■
Ports added to a LAG lose their individual port configuration. When ports are removed from
the LAG, the original port configuration is applied to the ports.
This section contains the following topics:
■
Configuring LAG Parameters
■
Configuring LAG Membership
■
Configuring LACP Parameters
6-4
. The port parameters are saved.
www.hp.com Embedded Web System User Guide